User Image User Image User Image User Image
Menu
User Image User Image User Image User Image

LISA20 Modules

  • LiSA20 module (LBM)
    Structure: On a carrier plate there are the LiSA20 PCBs, diverse fuses and corresponding module connectors as interfaces. The front panel contains operating terminal and telephone handset for voice communication to the machine room. 
    Control module (SModule) for lifts without machine room
    The SModule is nothing but the LBM in a separate housing with the respective prewiring for connection in the CBox. In case of hydraulic lifts, the emergency rescue pump is additionally placed here.
    We currently envisage the delivery of four different SModule types:
    SModule for rope-traction lifts
    SModule for GMV hydraulics
    SModule for Bucher
    SModule for Algi
    The module must not necessarily be installed in the door frame. Installation into the masonry or surface mounting (onto the masonry, door frame) is equally possible.


  • LiSA20 is an innovative, future-oriented control system. Thanks to the two-part construction (processor board 95 x 290 x 20 mm and relay board 95 x 290 x 40 mm), this system can be used even if space is very limited. The boards can be installed above each other, next to each other or, in small areas, even separately. This allows to decouple the electronic components from the mains supply side and thus helps to avoid EMC-technical problems. It complies with the requirements of EN12015 (emission) and EN12016 (immunity).
     
    A new concept has been integrated in LiSA20 in order to select different user levels for simple supported access to the controller. This is to make a distinction between operator, service mechanic and core team. Depending on the selected authorisation using the coded USB stick, specific functions can be selected in the controller.
     
    Thanks to its interfaces like LiSA bus, CANopen, DCP, modem, COM server, USB and SD card, it is all geared for future tasks.
    Using state-of-the-art components and the sophisticated structure allow for the operation at minimum consumption. Functions like light off, display off, inverter in standby operation, inverter and door drive off, provide for economic consumption values of the whole lift system.
     
    Processor board LiSA20
         		 Relay board LiSA20
         		 Handheld terminal LiSA20
     

     

  • Version S1: machine room version

    Controller structure:

    • Control cabinet with integrated inverter / inverter in the machine room
    • Supply and travelling cable connection in the control cabinet
    • Switches (recall, light, …) operable from the outside
    • Standard CModule with motor connection, short-circuit contactor, connection of the shaft-pit module, shaft light, safety wires, emergency limit switches, etc.
     

    Version S2 without machine room: standing cabinet version

    Controller structure:

    • Supply in the control cabinet
    • Travelling cable connection in the control cabinet / CBox
    • Switch for emergency rescue operable after door opened
    • CModule with inverter and motor connection, short-circuit contactor, connection of the shaft-pit module, shaft light, safety wires, emergency limit switches, etc.
     

    Version S3 without machine room: LAR version

    LAR control cabinet in the landing (installation in escape routes) as wall cabinet or in alcoves.

    Certified by Deutsches Bauinstitut!

    Controller structure:

    • Supply in the control cabinet
    • Travelling cable connection in the control cabinet / CBox
    • Switch operable after door opened
    • CModule with inverter and motor connection, short-circuit contactor, connection of the shaft-pit module, shaft light, safety wires, emergency limit switches, etc.

     

    • LiSA20 lift controller brochure in door frame- English
    • LiSA20 lift controller brochure - English
    • Catalogue and manual - English